Investigation on the effect of friction stir processing parameters on microstructure and microhardness of Rice Husk Ash (RHA) reinforced A16061 metal matrix composites (A1-MMC) /
Noor Farhana Mohd Daron
Investigation on the effect of friction stir processing parameters on microstructure and microhardness of Rice Husk Ash (RHA) reinforced A16061 metal matrix composites (A1-MMC) / Noor Farhana Mohd Daron - Kuantan, Pahang : UMP, 2016 - xviii, 86 p. : ill. (some col.) ; 30 cm. + 1 CD ROM
Faculty of Manufacturing Engineering
Project Paper (Bachelor of Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016
Bibliography: p. 79-82
Friction stir processing (FSP) is an alternative way to produce the surface composites of aluminium alloy in order to modify the microstructure and improve the mechanical properties of the aluminium alloy plate. In this experiment, Al6061 has been chosen to be used as a plate for the FSP. Al6061 has a potential material for advances application but it has low wear resistance. While, the reinforced used is rice husk ash (RHA) in order to produce surface composites to improve the distribution of particles and also increase the microhardness of the plate. The Al6061 has been stir with the 5% of RHA and 0% of RHA at three different tool rotational speeds of 800 rpm, 1000 rpm and 1200 rpm. After running the FSP, the result in the distribution of particles and the microhardness of the FSP occur has been identified. Result shows that Al6061 plate with the existing 5% of RHA reinforced at the highest of tool rotational speeds of 1200rpm in the surface area shows the better the distribution of particles and the higher the result in average of microhardness with 80Hv.
THE0005338(Local)
Faculty of Manufacturing Engineering--Dissertations
Universities and Colleges--Dissertations
Theses
Investigation on the effect of friction stir processing parameters on microstructure and microhardness of Rice Husk Ash (RHA) reinforced A16061 metal matrix composites (A1-MMC) / Noor Farhana Mohd Daron - Kuantan, Pahang : UMP, 2016 - xviii, 86 p. : ill. (some col.) ; 30 cm. + 1 CD ROM
Faculty of Manufacturing Engineering
Project Paper (Bachelor of Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016
Bibliography: p. 79-82
Friction stir processing (FSP) is an alternative way to produce the surface composites of aluminium alloy in order to modify the microstructure and improve the mechanical properties of the aluminium alloy plate. In this experiment, Al6061 has been chosen to be used as a plate for the FSP. Al6061 has a potential material for advances application but it has low wear resistance. While, the reinforced used is rice husk ash (RHA) in order to produce surface composites to improve the distribution of particles and also increase the microhardness of the plate. The Al6061 has been stir with the 5% of RHA and 0% of RHA at three different tool rotational speeds of 800 rpm, 1000 rpm and 1200 rpm. After running the FSP, the result in the distribution of particles and the microhardness of the FSP occur has been identified. Result shows that Al6061 plate with the existing 5% of RHA reinforced at the highest of tool rotational speeds of 1200rpm in the surface area shows the better the distribution of particles and the higher the result in average of microhardness with 80Hv.
THE0005338(Local)
Faculty of Manufacturing Engineering--Dissertations
Universities and Colleges--Dissertations
Theses