Normal view MARC view ISBD view

Design and fabrication of display unit for exploded components of single cylinder 4 stroke engine / Mohamad Faza Firdaus Mohd Rashid

By:

Mohamad Faza Firdaus Mohd Rashid

Material type: Text

TextPublication details: Kuantan, Pahang : UMP, 2012Description: xiii, 55 p. : ill. (some col.) ; 30 cm. + 1 CD-ROMISBN:

THE0006347(Local)

Subject(s):

Four-stroke cycle engines -- Design and construction

Dissertation note: Project paper (Diploma of Mechanical Engineering ) -- Universiti Malaysia Pahang - 2012 Abstract: This report shows the design and fabrication of the display unit for exploded component of single cylinder four stroke engine. The objective of the report is to develop the procedures to design and fabricate the display unit in exploded view for use of in teaching plan. Design generation is showed and solid three dimensional structure model was developed with the solid work software. Material selection and the reason behind the selection are shown based on criteria predetermined. Based on the selection, acrylic and steel are selected. This project is difficult to make because it is hard to find the references and information of similar project and it’s the method to arrange part of the engine. The results show each part of component can be successfully assembled.

Tags from this library: No tags from this library for this title. Log in to add tags.

Average rating: 0.0 (0 votes)

Holdings ( 2 )
Title notes ( 3 )

Holdings
Item type	Current library	Call number	Copy number	Status	Date due	Barcode
Final Year Report	UMPLIB PEKAN	TJ790 .F39 2012 rs Dip. (Browse shelf(Opens below))	1	Not for loan		0000065882
Final Year Report	UMPLIB PEKAN	CD 6137 \| TJ790 .F39 2012 rs Dip. (Browse shelf(Opens below))	1	Not for loan		0000065883

Project paper (Diploma of Mechanical Engineering ) -- Universiti Malaysia Pahang - 2012

Bibliography : p. 48

This report shows the design and fabrication of the display unit for exploded component of single cylinder four stroke engine. The objective of the report is to develop the procedures to design and fabricate the display unit in exploded view for use of in teaching plan. Design generation is showed and solid three dimensional structure model was developed with the solid work software. Material selection and the reason behind the selection are shown based on criteria predetermined. Based on the selection, acrylic and steel are selected. This project is difficult to make because it is hard to find the references and information of similar project and it’s the method to arrange part of the engine. The results show each part of component can be successfully assembled.