02053nam a2200265 a 4500 vtls000043024 KUKTEM 20251114204411.0 090902t2008 my a f m 000 0 eng d THE0005778(Local) 201905101559 aida 201107132222 VLOAD 200909021256 ida UMP TA418.7 .M64 2008 rs Bc. Raja Mohd. Raja Idris Relationship between machining parameters and surface roughness of brass using lathe machine / Raja Mohd. Raja Idris Relationship between machining parameters and surface roughness of brass using lathe machine [electronic resource] Kuantan, Pahang : UMP, 2008 39 p. : ill. (some col.) ; 30 cm. + 1 computer disc Project paper (Bachelor of Mechanical Engineering with Manufacturing) -- Universiti Malaysia Pahang - 2008 Surface roughness is a consequence of all machining operations and has been the subject of investigative research for the better part of the last century because the product produce good surface finish is very valuable. But, not all the product needs a good surface finish. If the product not demands a good surface finish, the time of machining can be reduce to minimize the cost. This is about the effect of machining parameters on surface roughness using lathe machine. The focus of this project is to study the effect of Cutting speed, feed rate, and depth of cuts on brass`s surface roughness. The experiment was design using Design of experiment (DOE) method and from which number of experiment was constructed. The result show that feed rate is the most effected parameter on surface roughness when machining process then followed by depth of cut and cutting speed. All the parameters are proportional with brass`s surface roughness. Surface roughness Surface (Technology) Brass 0 0 0 1 20000 20000 2019-09-04 0 TA418.7 .M64 2008 rs Bc. 0000038091 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 3399 | TA418.7 .M64 2008 rs Bc. 0000038092 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 1380 1386 VTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*6501*6502*9992