Raja Mohd. Raja Idris creator text theses my Kuantan, Pahang UMP 2008 monographic eng

print

electronic resource

39 p. : ill. (some col.) ; 30 cm. + 1 computer disc Surface roughness is a consequence of all machining operations and has been the subject of investigative research for the better part of the last century because the product produce good surface finish is very valuable. But, not all the product needs a good surface finish. If the product not demands a good surface finish, the time of machining can be reduce to minimize the cost. This is about the effect of machining parameters on surface roughness using lathe machine. The focus of this project is to study the effect of Cutting speed, feed rate, and depth of cuts on brass`s surface roughness. The experiment was design using Design of experiment (DOE) method and from which number of experiment was constructed. The result show that feed rate is the most effected parameter on surface roughness when machining process then followed by depth of cut and cutting speed. All the parameters are proportional with brass`s surface roughness. specialized Raja Mohd. Raja Idris Project paper (Bachelor of Mechanical Engineering with Manufacturing) -- Universiti Malaysia Pahang - 2008 Surface roughness Surface (Technology) Brass THE0005778(Local) UMP 090902 20251114204411.0 vtls000043024