01909nam a2200253 a 4500 vtls000042850 KUKTEM 20251114204420.0 090828t2008 my a f m 000 0 eng d THE0007479(Local) 201905161323 fawwaz 201204051138 Fida 201111241004 Fida 201107132247 VLOAD 200908281138 ida UMP TP1151.I55 S25 2008 rs Bc. Noorsakinah Shafie Simulation development, design and test of handset casing/ Noorsakinah Shafie Kuantan, Pahang : UMP, 2008 58 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Mechanical Engineering with Manufacturing) -- Universiti Malaysia Pahang - 2008 Injection molding process is the predominant method for producing plastic parts. Injection molded parts like handset casing are best designed through use of injection molding computer simulation because it can save the time and cost. The development of handset casing needs the optimum manufacturability parameters to maximize the quality of the products at lowest cost and highest productivity. There are many defects occurs at finished products when the parameters not defined precisely. This project is to investigate and defined the optimum manufacturing parameters of handset casing using a computer simulation. After reverse engineering of the selected product, the manufacturability parameters will be determined after the properties of product was determined. The properties of the products and manufacturability of the product will be defined using CAE tools and Moldflow Plastic Insight (MPI). Cellular telephones Plastics Molding Simulation Molding (Chemical technology) 0 0 0 1 20000 20000 2019-09-04 0 TP1151.I55 S25 2008 rs Bc. 0000038696 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 3546 | TP1151.I55 S25 2008 rs Bc. 0000038697 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 1646 1652 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5200*6500*6501*6502*9992