01837nam a2200217 a 4500001001400000003000700014005001700021008004100038020002200079040000800101100002200109245010100131246009700232260003400329300005900363502011100422520099200533650004301525650003001568650002101598vtls000039960KUKTEM20251114204421.0090709t2008    my a   f m    000 0 eng|d  aTHE0006635(Local)  aUMP0 aLatifah Md Yusoff10aExperimental analysis on drilling process of CFRP composite laminates /cLatifah Binti Md Yusoff3 aExperimental analysis on drilling process of CFRP composite laminatesh[electronic resource]  aKuantan, Pahang :bUMP,c2008  a67 p. :bill. (some col.) ;c30 cm. +e1 computer disc  aProject paper (Bachelor of Mechanical Engineering with Manufacturing) -- Universiti Malaysia Pahang - 20083 aThe principal aim of  this work  is  to optimize  the drilling process of composite   materials namely carbon fiber reinforced plastics (CFRP). Aspects of tool materials and   machining parameters on  their influence against the thrust force and delamination were  investigated.  The  chosen machining  parameters  are  feed  rate  and  spindle  speed.  The   optimization  process  was  achieved  by  a  method  called  General  factorial.  Through   analysis function (ANOVA) the factorial model was found to be significant since the P   value  is  0.0116  which  is  less  than  0.05.  Type  of  tools  is  the most  significant  factor   followed  by  spindle  speed.  The  less  significant  factor  is  feed  rate. The  optimal   parameters were SPF tool, 2000 rpm of spindle speed and 400 mm/min of feed rate. The   optimization  result  shows  that  this method was  reliable with desirability 0.815.  It was   found that the optimization process is achieved by Factorial Design. 0aDrilling and boringxComputer programs 0aFiber-reinforced plastics 0aDrilling presses