02464nam a2200205 a 4500001001400000003000700014005001700021008004100038020002200079040000800101100002200109245012700131260003400258300005700292502012300349504002800472520170200500650003402202650002202236vtls000045505KUKTEM20251114204424.0100503t2009    my ao  f m    000 0 eng|d  aTHE0007468(Local)  aUMP0 aMohd Nazri Ismail10aEffects of materials selection on injection moulding parameters using moldflow simulation software/cMohd Nazri Bin Ismail  aKuantan, Pahang :bUMP,c2009  axvi, 97 p. :bill. (some col.) ;c30 cm. +e1 CD-ROM  aProject paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2009  aBibliography : p. 61-623 aThis dissertation deals with the effects of material selection on injection moulding parameters using Moldflow simulation software. The objective of this dissertation is to define suitable material in producing plastic product (book tray) in term of Profit. The dissertation also describes the finite element analysis techniques to know the effect of cycle time to production cost and reduce the cost in define the material selection using manual method. Eight plastic materials were studied in this dissertation which commonly used in industrial. The three-dimensional solid modelling of plastic product (book tray) was developed using the computer-aided drawing software. The dimension of product based on the actual product mould. The three-dimensional solid modelling of plastic product will import to the computer aided engineering software. The computer aided engineering software was then performed is using Moldflow (MPI) simulation software. The computer aided engineering model of product was analyzed using injection flow analysis. The analysis need to repeat three time for each eight material. Finally, the average value of cooling time (s), filling time (s), and initial injection time (s) obtained from the analysis. From those parameters, the cycle time of product producing can be calculated for each eight material. The cycle time can relate to the production capacity, product cost and profit. From that comparison, the best material for plastic product (book tray) can be selected and also can know the effect of cycle time only on processing cost. By using this analysis method also can reduce the cost in define the material selection for plastic product using manual method. 0aInjection molding of plastics 0aPlasticsxMolding