02011nam a2200265 a 4500 vtls000045504 KUKTEM 20251114204425.0 100503t2009 my ao f m 000 0 eng|d THE0007478(Local) 201905161322 fawwaz 201107132316 VLOAD 201005031628 ida UMP TP1150 .Z85 2009 rs Bc. Ahmad Zulhelmi Muhamad Mold design for plastics injection molding process (two colors) and analysis of gates location/ Ahmad Zulhelmi Bin Muhamad Mold design for plastics injection molding process (two colors) and analysis of gates location [electronic resource] Kuantan, Pahang : UMP, 2009 xviii, 80 p. : ill. (some col.) ; 30 cm. + 1 computer disc Project paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2009 Bibliography : p. 68-69 This thesis describe about the mold design for plastic injection molding process for two colors and the analysis of gate location in order to find the best gate location to apply it in to the design. The molds for injection molding is not the cheap one it is expensive and needed an accurate step when apply the design on the mold because a slice mistake can follow by big loss. First step is about finding the best gate location from several gate location have been choose but before that the design of the product and it materials should be choose. After the analysis have done, the collected data from several gate location will be compare in order to find best gate location and apply it in the mold design. To designing mold, the several system like runner system, injector system and the ways material enter the mold will be considered. Injection molding of plastics Plastics Molding 0 0 0 1 20000 20000 2019-09-04 0 TP1150 .Z85 2009 rs Bc. 0000044289 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 4168 | TP1150 .Z85 2009 rs Bc. 0000044290 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 1782 1788 VTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992