01654nam a2200217 a 4500001001400000003000700014005001700021008004100038020002200079040000800101100001700109245006200126246007000188260003500258300006400293502009100357504002500448520092500473650002101398650001701419vtls000046503KUKTEM20251114204432.0100622t2009    my dao f m    000 0 eng d  aTHE0005710(Local)  aUMP0 aSoh, Yan Xin10aDesign and fabrication of drop test device /cSoh Yan Xin3 aDesign and fabrication of drop test deviceh[electronic resource]  aKuantan, Pahang :bUMP ,c2009  axvi, 72 p. :bill. (some col.) ;c30 cm. +e1 computer disc  aProject paper (Diploma of Mechanical Engineering) -- Universiti Malaysia Pahang - 2009  aBibliography : p. 503 aThis thesis deals with the design and fabrication of drop test device. The objective of this thesis is to design and fabricate a drop test device for Integrated Telephone System (ITS) model. The thesis describes the methods of designing and fabricating the drop test device. There are many steps taken to design and fabricate this device. The structural three-dimensional solid modelling of drop test device was developed by using the SolidWorks engineering drawing software. The fabrication process also undergoes many steps such as material marking, cutting, drilling, welding, grinding and finalizing the drop test device by painting. Other than that, it explains the standard operating procedure for testing this device. The results of testing the prototype also discussed in this thesis. Finally, the conclusion about this project and the recommendations for the future plan also attached together with this thesis. 0aTesting-machines 0aNew products