02115nam a2200265 a 4500 vtls000052154 KUKTEM 20251114204442.0 110321t2010 my a f m 000 0 eng d THE0007151(Local) 201906131229 hanafiah 201110041216 Fida 201107140039 VLOAD 201103211159 ida UMP TL214.F78 R35 2010 rs Bc. Raja Sharul Azuan Raja Kamaralzaman Development of liquid spray triggering and control / Raja Sharul Azuan Raja Kamaralzaman Development of liquid spray triggering and control [computer file] Kuantan, Pahang : UMP, 2010 xiv, 47 p. : ill. (some col.) ; 30 cm. + 1 computer disc Project paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2010 Bibliography : p. 41 This project presents the study about development of liquid spray triggering and control in a direct injection gasoline injector of a gasoline engine. The objectives of the study is to develop control system using a parameters of time and pressure in order to identify the spray characteristics including spray angle, spray tip penetration and spray width. The scopes of this research are choosing control system due to type of injection, setup test rig for experimental using high pressure chamber and develop control and triggering system in order to control the timing and delay of the injector. After test rig fabrication is done and all equipment has been setup, experiment is done by supplying pressure at 4 Bar from high pressure pump to fuel injector that attach to high pressure chamber. Ambient temperature was set to 300 K and ambient pressure is 0.1 Mpa. Simple triggering and control has been developing using MATLAB Simulink and the result was analyzed due to sample of calculation. Automobiles Motors Fuel injection systems Automobiles Motors (Compressed-gas) 0 0 0 1 20000 20000 2019-09-04 0 TL214.F78 R35 2010 rs Bc. 0000054165 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 5098 | TL214.F78 R35 2010 rs Bc. 0000054166 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 2287 2293 VTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992