01883nam a2200205 a 4500001001400000003000700014005001700021008004100038020002200079040000800101100002300109245009000132260003800222300006400260502013200324504002400456520116100480650001301641650002301654vtls000018619KUKTEM20251114204449.0070312t2006    my a   f      000 0 eng d  aTHE0006072(Local)  aUMP0 aNorhayati Mat Noor10aDevelopment of pick and place system using IRB 1400 robot /cNorhayati Binti Mat Noor  aKuantan, Pahang :bKUKTEM ,c2006  axiv, 70 p. :bill. (some col.) ;c30 cm. +e1 computer disc  aProject paper (Bachelor of Electrical Engineering (Electronics)) -- Kolej Universiti Kejuruteraan dan Teknologi Malaysia - 2006  aBibliography: p. 54  aMany robots have been built for manufacturing purposes and can be found in factories around the world .The idea behind this project is to reduce the utilization of human energy especially in manufacturing industry. The project involves of development pick and place system a using ABB IRB 1400 industrial robot. In this project, the IRB 1400 robot was program to perform pick and place task. The robot was equipped with robotic sensor to detect the work pieces. Using the ABB robot’s Rapid software, the program was downloaded to the robot controller, S4Cplus. By teaching the robot points with the Teach Pendants, we can execute the ABB robot program sequences. In the manufacturing system, conveyor work as a method of work part delivery. Model of small conveyor was constructed to delivery the work pieces from the incoming part. The sensors were mounted to the conveyor, which is to sense the incoming material and also to control the operation of the conveyor motor. The robot that was programmed will pick and place the material in the outgoing part. The operation of the system working continuously since the sensor detected the incoming material. 0aRobotics 0aRobots, Industrial