02878nam a2200253 a 4500 vtls000040470 KUKTEM 20251114204455.0 090716t2008 my a f m 000 0 eng|d THE0007251(Local) 201905141058 fawwaz 201107132306 VLOAD 200908141649 VLOAD 200908141629 VLOAD 200907161513 ida84 UMP TL255 .F57 2008 rs Bc. Muhammad Firdaus Mahmud Improvement of front car bumper system / Muhammad Firdaus Mahmud Improvement of front car bumper system [electronic resource] Kuantan, Pahang : UMP, 2008 50 p. : ill. (some col.) ; 30 cm. + 1 computer disc Project paper (Bachelor of Mechanical Engineering with Automotive) -- Universiti Malaysia Pahang - 2008 Designing the bumper with the focus on an improvement aspect is very important in the automotive industry. The goals are to increase the performance of the bumper and also to find the solution to reduce the cost of the bumper hence able to reduce the production cost. The costs of the bumper is high because of the amount of material used and it also involves many processes including making the grille at the center of bumper. The new design considers on reducing the amount of material use and also eliminating the process involve in manufacture the bumper for example eliminating the grille attachment. The new design also must improve the ability to absorb more impact load and increase the protection of the front car component. This project intention is to design an improved of front car bumper and to find the solution for the problem of high cost and the replacing cost for the front bumper and lastly emphasizing the cost reducing aspect. The method have been employed was study the front bumper system, design and analyze the alternative front bumper using CAD software. The suitable material that can be used as the bumper in terms of economical but still maintaining the toughness is Plastic-Polycarbonate (Molded) which is not expensive compare to the best material from the analysis E-Glass Fiber, Plastic-Nylon Type 6/6 and Plastic ABS (Molded). The suitable material to be use for making beam is AISI E 52100 Steel. Rearrangement of the mounting positions gives a different effect on the ability to withstand the impact force. Additional plate in the improvement design proved increasing the toughness of the beam Automobiles Bumpers Design and construction Automobiles Safety appliances 0 0 0 1 20000 20000 2019-09-04 0 TL255 .F57 2008 rs Bc. 0000038288 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 3497 | TL255 .F57 2008 rs Bc. 0000038289 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 2647 2653 VTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*6501*9992