02067ntm a2200241 a 4500 vtls000082987 KUKTEM 20251114204335.0 141104t2013 my da f m 000 0 eng|d THE0005640(Local) 201905171457 hanafiah 201411051001 training2 201411041233 training2 UMP TA356 .N67 2013 r Bc. Mohamad Norfaiza Anuar Mahmood Measurement and validation of fluid structure interface / Mohamad Norfaiza Anuar Mahmood Kuantan, Pahang : UMP, 2013 xvi, 69 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project Paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang – 2013 Bibliography : p. 70-71 This thesis is done to study about structure of pipeline network when it vibrated. The vibration of the structure can lead to problem. The objectives of the study are to determine the mode shape and natural frequency when the structure is vibrated. Besides that, in this study we also need to verify the data that obtain. The method that will be use to conduct this study is experimental and simulation of pipeline network. In experimental we need to build the pipeline network structure. The design must consider the workplace. In simulation we need to draw the design of pipeline network in solidwork software, the parameter must follow in experimental method. This is because if use different parameter the data between both will be different. After that, comparison of the data between these two methods must be done, this is because the data must be verify whether it valid or not. The result will show the mode shape and natural frequency of structure. If the data is not valid the experiment need to be repeat until get the same data or approximately same. The data will be valid if the error between these two results is below than 5%. Fluid mechanics 0 0 0 1 20000 20000 2019-09-04 0 TA356 .N67 2013 r Bc. 0000086438 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 0 20000 20000 2019-09-04 0 CD 8159 | TA356 .N67 2013 r Bc. 0000086439 2019-09-04 00:00:00 1 2019-09-04 ACCOM VIRTUA40 325 331 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992