01522nam a2200193 a 4500001001400000003000700014005001700021008004100038020002200079040000800101100003700109245013800146260003400284300005800318502009200376504002500468520078000493650005501273vtls000063511KUKTEM20251114204519.0120813t2012    my da  f m    000 0 eng d  aTHE0006347(Local)  aUMP0 aMohamad Faza Firdaus Mohd Rashid10aDesign and fabrication of display unit for exploded components of single cylinder 4 stroke engine /cMohamad Faza Firdaus Mohd Rashid  aKuantan, Pahang :bUMP,c2012  axiii, 55 p. :bill. (some col.) ;c30 cm. +e1 CD-ROM  aProject paper (Diploma of Mechanical Engineering ) -- Universiti Malaysia Pahang - 2012  aBibliography : p. 483 aThis report shows the design and fabrication of the display unit for exploded component of single cylinder four stroke engine. The objective of the report is to develop the procedures to design and fabricate the display unit in exploded view for use of in teaching plan. Design generation is showed and solid three dimensional structure model was developed with the solid work software. Material selection and the reason behind the selection are shown based on criteria predetermined. Based on the selection, acrylic and steel are selected. This project is difficult to make because it is hard to find the references and information of similar project and it’s the method to arrange part of the engine. The results show each part of component can be successfully assembled. 0aFour-stroke cycle enginesxDesign and construction