01636nam a2200253 a 4500 vtls000065384 KUKTEM 20251114204521.0 121023t2012 my da f m 000 0 eng d THE0006594(Local) 201905161046 amirul 201211081443 huda 201211071302 huda 201210231221 huda UMP TJ1191 .S53 2012 rs Bc. Ahmad Shahrul Amrie Mohd Supri The study on the effect of laser power on kerf width for carbon dioxide laser cutting process / Ahmad Shahrul Amrie Mohd Supri Kuantan, Pahang : UMP , 2012 xiv, 51 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Manufacturing Enginnering) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 45-49 This study focuses on the effect of laser power on kerf width using CO2 laser machine. The experiment was conducted by using laser cutting process on 2.5 mm thick of acrylic sheet. The laser cutting parameters considered include laser power and cutting speed. The good cut quality for laser cutting process has a uniform with smaller kerf width. The effect of the laser cutting parameter on the cut quality was further investigated by monitoring the kerf width using image analyzer. After performed the experiment and analysis it shows that the lower laser power and higher cutting speed produce narrower kerf width. Laser beam cutting Carbon dioxide lasers 0 0 0 1 20000 20000 2019-09-04 0 TJ1191 .S53 2012 rs Bc. 0000067445 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6281 | TJ1191 .S53 2012 rs Bc. 0000067446 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3401 3407 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992