02126nam a2200253 a 4500 vtls000065536 KUKTEM 20251114204522.0 121101t2012 my da f m 000 0 eng d THE0007507(Local) 201905161442 fawwaz 201211080930 huda 201211011456 huda UMP TS156 .S93 2012 rs Bc. Mohamad Syahmi Shahrom Taguchi method approach on effect of lubrication condition on surface roughness in milling operation / Mohamad Syahmi Shahrom Kuantan, Pahang : UMP , 2012 xiv, 77 p. : ill. (some col.); 30 cm. + 1 CD-ROM Project paper (Bachelor of Manufacturing Engineering) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 71-73 This thesis presents an investigation into the MQL (minimum Quantity Lubrication) and wet machining in milling processes of AISI 1060 Aluminum work material with the main objective is to determine the effect of lubrication conditions on the surface roughness. Two types of insert had been used in this research, which is different in geometry selection is radius 0.8mm and 1.2mm. Three other parameters were also considered in this study; feed rate, depth of cut and cutting speed. The levels each parameter had been selected is four levels. The ranges of feed rate 0.05mm/min, 0.15mm/min,0.20mm/min and 0.25mm/min depth of cut used were 0.2mm, 0.4mm, 0.6mm and 0.8mm whereby the cutting speed values were 600mm/min, 800mm/min, 1000mm/min and 1200mm/min. The surface roughness was evaluated using surface roughness tester Mitutoyo. Taguchi method was used to predict the surface roughness. Finally, the experimental results showed good agreement with the estimated results. It was found that, MQL produced better surface finish as compared to wet machining. The result can significantly reduce cost and environmental pollution. Taguchi methods (Quality control) Surface roughness 0 0 0 1 20000 20000 2019-09-04 0 TS156 .S93 2012 rs Bc. 0000067450 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6283 | TS156 .S93 2012 rs Bc. 0000067451 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3429 3435 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992