01984nam a2200253 a 4500 vtls000065324 KUKTEM 20251114204527.0 121022t2012 my da f m 000 0 eng d THE0007497(Local) 201905161436 fawwaz 201211081437 huda 201211071250 huda 201210221707 huda UMP TS155.8 .N38 2012 rs Bc. Muhamad Nasruldin Hashim Implementation of single minute exchange die (SMED) technique to accelerate the mold changing time at sme company / Muhamad Nasruldin Hashim Kuantan, Pahang : UMP, 2012 xiv, 84 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Manufacturing Engineering) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 73-76 The purpose of the Single Minute Exchange Die (SMED) is to eliminate waste of time. Longer set-up time means that the production line is not productive and will left behind by their competitor. Nowadays, everything is been done faster and just-in-time, where manufactures need to produced product in fast and without neglecting the quality issue and deliver it to customer right on time. In this project, SMED had provided the method to eliminate waste of time with their eight technique of SMED introduced by Mr. Shigeo Shingo. In SMED mold or die exchange should be less in 10minute and it took lots of improvement involve by the employee. The project objective is to reduce mold set-up time to 40% is exceeding the expectation where they able to reduce until 51% from the total setup time previously. In overall with the help of everyone, especially from top management of company to their employee, SMED is successfully done and achieve the objective. Production control Production management 0 0 0 1 20000 20000 2019-09-04 0 TS155.8 .N38 2012 rs Bc. 0000067431 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6274 | TS155.8 .N38 2012 rs Bc. 0000067432 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3571 3577 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992