01733nam a2200265 a 4500 vtls000067037 KUKTEM 20251114204530.0 121128t2012 my da f m 000 0 eng d THE0006544(Local) 201905141527 amirul 201211281042 huda UMP TJ1186 .N33 2012 rs Bc. Nadirah Ismail Influence of varying depth of cut and feed rate to tool wear rate and surface roughness in aluminium, mild steel and P20 tool steel : Nadirah Ismail Kuantan, Pahang : UMP, 2012 xv, 53 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Manufacturing Engineeing) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 46 Since the phenomenon of tool life still not fully understood although many research and case study have been done before, an investigation on the tool wear rate and surface roughness value being done for three types of workpiece material which are aluminium, mild steel and P20 while cutting tool that been used is carbide coated insert. The main reason for this investigation is to study and understand the behavior of cutting tool in order to determine the tool wear rate and tool life. From this investigation, surface roughness value for each type of workpiece material, Ra also can be collected. This investigation been done by applying high speed machining (HSM) concept, which high feed rate with light depth of cut. Cutting tools Cutting tool design Suface roughness 0 0 0 1 20000 20000 2019-09-04 0 TJ1186 .N33 2012 rs Bc. 0000067385 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6254 | TJ1186 .N33 2012 rs Bc. 0000067386 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3670 3676 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*6502*9992