01905nam a2200253 a 4500 vtls000066760 KUKTEM 20251114204531.0 121122t2012 my da f m 000 0 eng d THE0007589(Local) 201905171116 fawwaz 201211291120 huda 201211291119 huda 201211271504 huda 201211221014 huda UMP TS171.4 .K66 2012 rs Bc. Koo, Nelton Chwee Yang Design of wind tunnel (fluid flow analysis) / Nelton Koo Chwee Yang Kuantan, Pahang : UMP, 2012 xvii, 53 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Manufacturing Engineering) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 47-48 A low speed wind tunnel was design and fabricate. The project covered the process of design and fabrication of the small wind tunnel. In completing this project, a computer aided drawing (CAD) called Solid Work is use to design the wind tunnel. Experiment conducted after build the wind tunnel to find drag coefficient of a sphere. The drag force on a sphere in an air stream was measured at various free stream velocities below 100 m/s. This was done in a low speed wind tunnel using an integral balance system to measure the drag force and a Pitot tube and to measure the velocity. The raw data were processed according to classical equations of fluid mechanics which define the drag coefficient. An impression of fluid field flow around a sphere is also capture using white smoke. Method of analysis the flow in test section was shown by using strings. The experimental results are compared to published results over the range tested. Wind tunnels Production engineering 0 0 0 1 20000 20000 2019-09-04 0 CD 6258 | TS171.4 .K66 2012 rs Bc. 0000067395 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 TS171.4 .K66 2012 rs Bc. 0000067394 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3683 3689 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992