01945nam a2200265 a 4500 vtls000069522 KUKTEM 20251114204536.0 130514t2012 my da f m 000 0 eng d THE0007346(Local) 201905151014 fawwaz 201305141143 Fida UMP TL278 .M84 2012 rs Bc. Muhammad Mohd Noor Cost reduction study of automotive part using dfa method : car seat / Muhammad Mohd Noor Kuantan, Pahang : UMP, 2012 xvi, 109 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Mechanical Engineering with Automotive Engineering) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 105 Design for Assembly (DFA) has been widely used in industry and has produced many successes. Some of the methods known in the DFA industry now are the BoothroydDewhurst DFA method, Hitachi Assemblability Evaluation Method (AEM) and the Lucas –Hull DFA method. With these well-known methods, many important changes and developments carried out either manually or through the automatic assembly. The goals of this project are to analyse existing car seat using Boothroyd-Dewhurst DFA and Hitachi Assemblability Evaluation Method (AEM) in terms of assembly time, assembly cost and assembly efficiency. The car seat that has been used in this project is a car seat of Proton Wira. The original car seat has been analysed and showed that Boothroyd-Dewhurst DFA has low percentage design efficiency compare to Hitachi AEM DFA method. The assembly cost of both methods is same. The assembly time of both methods also calculated. Automobiles Design and construction Automobile industry and trade Production engineering 0 0 0 1 20000 20000 2019-09-04 0 TL278 .M84 2012 rs Bc. 0000069780 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6641 | TL278 .M84 2012 rs Bc. 0000069781 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3823 3829 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*6502*9992