02074ntm a2200241 a 4500 vtls000072675 KUKTEM 20251114204536.0 130624t2012 my da f m 000 0 eng d THE0005623(Local) 201905171147 hanafiah 201306241643 huda 201306241532 huda 201306241532 huda 201306241532 huda UMP TA347.F5 N67 2012 rs Bc. Norsyazwani Badilah Effect of radius of fillet on shear stress for cylindrical shaft / Norsyazwani Badilah Kuantan, Pahang : UMP, 2012 xvi, 57 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Mechanical Engineeringwith Automotive) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 38-39 This project presents an investigation effect of the radius of the fillet on shear stress for cylindrical shaft by using finite element analysis. The shaft has the tendency to fail due to the inappropriate design of fillet radius. Hence, the best models need to design. 18 models were constructed with different ratio two diameters shaft and radius of fillet in SOLIDWORK. These models imported into PATRAN software to analyze the models with different given of the value of torque. In order to simulate torque, MPC RBAR was employed on model. AISI 4130 was selected material for all models. The value for Young Modulus of Elasticity = 206GPa and the Poisson Ratio = 0.3 was used in this analysis. The stress concentration factor was determined to compare the simulation result and equation. As expected, result showed that increased the radius of fillet of shaft reduced the value of shear stress. The ratio of two diameters shaft 1.09 was the best design compared to others because all cases produced the lowest value of shear stress. The value of shear stress was increase when the torque given was increased. Finite element method 0 0 0 1 20000 20000 2019-09-04 0 TA347.F5 N67 2012 rs Bc. 0000072677 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6866 | TA347.F5 N67 2012 rs Bc. 0000072678 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3831 3837 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992