01745ntm a2200253 a 4500 vtls000072757 KUKTEM 20251114204537.0 130626t2012 my da f m 000 0 eng d THE0007715(Local) 201905241037 fawwaz 201306261052 huda 201306261051 huda UMP TS250 .S53 2012 rs Bc. Mohd Shahril Mohd Hassan Experimental and numerical study on sheet metal lateral bending with both ends fixed / Mohd Shahril Mohd Hassan Kuantan, Pahang : UMP, 2012 xv, 50 p. : ill. (some col.) ; 30 cm + 1 CD-ROM Project paper (Bachelor of Mechanical Engineering (Manufacturing)) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 46-47 The main aim of this study is to compare the buckling phenomenon of sheet metal strip under both ends fixed setting. This study begins with a literature study. It was followed by design and fabrication of test equipment for strip buckling test. Initial research works was on design the test rig using solidwork software. The fabrication test rig consists of four different buckling test conditions. In this thesis, experimental and numerical investigation was dedicated to both ends fixed. Using the fabricated test rig, experimental was conducted to determine displacement and strain of the buckle specimen. Data from experiment have been compared with numerical modeling using Abaqus software. The results show good agreement between experimental and numerical analysis. Sheet-metal work Bending 0 0 0 1 20000 20000 2019-09-04 0 TS250 .S53 2012 rs Bc. 0000072685 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6870 | TS250 .S53 2012 rs Bc. 0000072686 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3849 3855 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992