02116nam a2200241 a 4500 vtls000073709 KUKTEM 20251114204540.0 130723t2012 my dao f m 000 0 eng d THE0004368(Local) 201905161120 rohana 201307231440 huda UMP TP248.P5 2012 rs Bc. Muhamad Azahari Abd Rahman Evaluation of molecularly imprinted polymer in flat sheet membrane for BPA separation / Muhamad Azahari Abd Rahman Kuantan, Pahang : UMP, 2012 xii, 50 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Chemical Engineering in Biotechnology) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 42-44 Bisphenol A (BPA) is among the highest chemical produced worldwide with over six billion pounds produced annually. Due to the effect that it can bring to humans’ health, techniques to decrease the exposure of BPA have been studied and one of them is by adsorption. In this works, BPA-MIP powder was produced by polymerization process using trimethylolpropane trimethacrylate (TRIM) and Bisphenol A dimethacrylate (BADM) under suspension polymerization. Bisphenol A (BPA) imprinted polyethersulfone (PES) and polysulfone (PSf) flat sheet membrane were produced using phase inversion method and the membrane for each polymer produced was prepared to be bound with the BPA in aqueous solution. The BPA transport behavior was studied in membrane forms using UV-Vis Spectrophotometer, Fourier Transform Infrared (FTIR), and Scanning Electron Microscope (SEM). The use of MIP embedded flat sheet membrane increase the adsorption due to the larger amount of binding sites in the membrane, comparing to non-imprinted membrane. The BPA-MIP polyethersulfone (PES) membrane give higher binding amount of BPA which was 16.61 μmol/g compared to BPA-MIP polysulfone (PSf) membrane which was 10.23 μmol/g. Bisphenol A. 0 0 0 1 10000 10000 2019-09-04 0 TP248.P5 2012 rs Bc. 0000075012 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 10000 10000 2019-09-04 0 CD 7205 | TP248.P5 2012 rs Bc. 0000075013 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 3926 3932 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992