02074nam a2200241 a 4500 vtls000077842 KUKTEM 20251114204558.0 140428t2012 my a f m 000 0 eng d THE0005618(Local) 201905171140 hanafiah 201404281537 training4 UMP TA347.F5 H34 2012 rs Bc. Muhammad Hafiz Azam Experimental and finite element evaluation of bending for aluminium / Muhammad Hafiz Azam Kuantan, Pahang : UMP, 2012 xv, 87 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper ( Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2012 Bibilography : p. 66-67 This thesis studies the effect of anisotropy to the deformation of springback in sheet metal forming and reliability of finite element method in sheet metal bending of Aluminium 1100 with the thickness 1 mm. This thesis focuses on tensile test experiment, bending experiment and finite element experiment. Tensile test experiment was done to determine the material properties of aluminium to put in the finite element simulation. The bending process was done using U-die to define the angle of springback in aluminium. The finite element simulation was done by using ABAQUS 6.7 to determine the angle of springback. The results of the experiments were analysed in order to determine the reliability of finite Element. The results show springback increased when the angle of rolling direction is higher. The lowest angle of springback was occurs at the 0° of rolling direction. Based on project, it was concluded that the parameters of anisotropy affect springback angle. It was found the 0° provides a suitable condition in U-die bending process. The finding from this project is the finite element method might be use in order to predict the springback angle of die designing. Finite element method 0 0 0 1 20000 20000 2019-09-04 0 TA347.F5 H34 2012 rs Bc. 0000072745 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6900 | TA347.F5 H34 2012 rs Bc. 0000072746 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 4465 4471 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992