02079nam a2200229 a 4500 vtls000077908 KUKTEM 20251114204604.0 140506t2012 my a m 000 0 eng d THE0005777(Local) 201905101558 aida 201405060918 training3 UMP TA418.7 .L69 2012 rs Bc. Lo, Wei Hou Optimization of cutting parameters and surface roughness on dry turning of low carbon steel / Lo Wei Hou Kuantan, Pahang : UMP, 2012 Project paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2012 Bibliography : p. 69-70 Cutting fluid play a very important role in machining but it also brings a lot of detrimental effects such as health hazards and environmental pollutions when it handled improperly. In addition, the cutting fluids also increase the amount of machining cost since it had been issues lately of its cost frequently higher than the cost of cutting tools. With this issue, dry machining becomes one of the solutions to solve this problem. The objective of this project is to optimize the cutting parameters and surface roughness on dry machining. Material chosen to be perform in this study is low carbon steel AISI 1019. The experiment is carried out with a full factorial design of 3 cutting parameters with 3 levels each onto dry Lathe machining. The surface roughness of workpiece is measured by using perthometer and the result is analyzed statistical by using STATISTICA software version 7.1. The optimum cutting parameters and surface roughness can be investigated through the ANOVA prediction with a level of confident 95 percent. The result investigate can help the industries to solve the problem by applying the investigated values of parameters not only in reducing the machining cost but also present a more environmental friendly machining operation. Surface roughness 0 0 0 1 20000 20000 2019-09-04 0 TA418.7 .L69 2012 rs Bc. 0000072799 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6927 | TA418.7 .L69 2012 rs Bc. 0000072800 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 4641 4647 VTLSSORT0080*0200*0400*0900*1000*2450*2600*5020*5040*5200*6500*9992