01975nam a2200241 a 4500 vtls000078049 KUKTEM 20251114204605.0 140508t2013 my a f m 000 0 eng d THE0005995(Local) 201905151053 aida 201406171530 Fida 201405081018 training3 UMP TC1662 .O54 2013 rs Bc. Ong, Pui Sze Design, analyse and manufacture propeller blade for remotely underwater vehicle / Ong Pui Sze Kuantan, Pahang : UMP, 2013 xvi, 72 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Engineering in Manufacturing) -- Universiti Malaysia Pahang – 2013 Bibliography : p. 56-59 This thesis contains details on the designing a propeller for the Remotely Underwater Vehicle. Remote Operated Vehicles (ROV) is a technology which is frequently used to service the military, ocean engineering activities and also commercial activities such as oil and gas industry. Propulsion plays a significant role in the manoeuvrability of the ROV. The objective of this paper is to conduct simulation studies to design and modelling the ROV propeller blade, and then manufacture the prototype by using Fused Deposition Modeling machine. OpenProp, an open-sourcedprogram developed at Massachusetts Institute of Technology is used to design the propeller and analyse the on-design performance of it. It is found that there is a deviation of 14% to 19% on the experimental results compared to the theoretical results. This might cause by wall effects that occurs on the tank, and surface roughness and blunt trailing edge of the blade prototype. In conclusion, improvement on the experimental setup is needed in order to obtain a much accurate results. Vehicles, Remotely piloted 0 0 0 1 20000 20000 2019-09-04 0 TC1662 .O54 2013 rs Bc. 0000080336 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 7770 | TC1662 .O54 2013 rs Bc. 0000080337 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 4681 4687 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992