02020nam a2200241 a 4500 vtls000077837 KUKTEM 20251114204610.0 140428t2012 my a f m 000 0 eng d THE0006246(Local) 201905161221 aida 201404281214 training4 UMP TJ260 .N53 2012 rs Bc. Nicholson Anak Jambok Experimental evaluation of heat flow through staggered pin fin array by forced convection / Nicholson Anak Jambok Kuantan, Pahang : UMP, 2012 xv, 61 p. : ill. ; 30 cm. + 1 CD-ROM Project paper ( Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2012 Bibilography : p. 57-58 An experimental evaluation of heat flow through staggered pin fin array by forced convection was set up in the thermodynamics laboratory for purpose of thesis study. All the main parameters that can significantly influence the heat transfer performance of staggered pin fin arrays have been examined thoroughly. An experimental set-up was designed to study the heat transfer performance inside the duct channel. The material is used in laboratory is called mild steel and its fins assembly with the plate heater. The pin fins was cylindrical in shape. The total number of fin was 23 fins attached on the base of the plate heater. The length of the fin was 12 cm with the diameter of 1 cm. The base area covered 9.5 cm x 9.3 cm. The transverse pitch, longitudinal pitch, and the diagonal pitch were 2cm, 2cm, and 1.5 cm respectively. Air was used as a working fluid in the experiment. Reynolds Number, Nusselt Number, and the Prandtl Number are the equations that use in heat transfer calculation. The result of findings will be taken into further experimentation through some critical results, discussion and conclusion. Heat Transmission 0 0 0 1 20000 20000 2019-09-04 0 TJ260 .N53 2012 rs Bc. 0000072747 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 6901 | TJ260 .N53 2012 rs Bc. 0000072748 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 4847 4853 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992