01712ntm a2200241 a 4500 vtls000079352 KUKTEM 20251117113228.0 140603t2013 my a f m 000 0 eng d THE0007183(Local) 201905131527 fawwaz 201406061023 training2 201406060913 Fida 201406031014 training2 UMP TL221.15 .A45 2013 rs Dip. Muhammad Amir Akmal Ahamad Khalid Fabrication of hybrid electric chopper tyre motorcycle front suspension / Muhammad Amir Akmal Ahamad Khalid Kuantan, Pahang : UMP, 2013 x, 35 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Diploma of Mechanical Engineering) -- Universiti Malaysia Pahang - 2013 Bibliography : p. 34 This thesis discussed the process of fabricating of hybrid electric chopper type motorcycle front suspension system. Firstly, the current chopper type motorcycle and hybrid system are studied. The studies include the design, advantages, disadvantages, material and installation. Later, the concept is selected for further studies which involving three dimensional modeling by using software SolidWorks. The fabrication of this hybrid electric chopper type motorcycle front suspension system is later do because the chassis first. The found out of problems also included. The problems covered from the start till project ends. Lastly, the conclusion of the project is documented and given some recommendation for further studies on the project. Hybrid electric vehicles 0 0 0 1 20000 20000 2019-09-04 0 TL221.15 .A45 2013 rs Dip. 0000085341 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 7971 | TL221.15 .A45 2013 rs Dip. 0000085342 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 5053 5059 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992