02749ntm a2200265 a 4500001001400000003000700014005001700021008004100038020002200079039006900101040000800170090002800178100002500206245010200231260003400333300005700367502009200424504002700516520155800543650002602101952012202127952013202249999002502381999007702406vtls000081947KUKTEM20251117113229.0141016t2013    my da  f m    000 0 eng d  aTHE0005615(Local) 9a201905171137bhanafiahc201411051230dsafuray201410161253zFida  aUMP  aTA347.F5 F35 2013 r Bc.0 aFakhrurrazi Ab Karim10aExperimental and finite element evaluation of bending for galvanized iron /cFakhrurrazi Ab Karim  aKuantan, Pahang :bUMP,c2013  axvi, 64 p. :bill. (some col.) ;c30 cm. +e1 CD-ROM  aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2013  aBibliography : p.57-583 aFinite element evaluation is one of the methods in predicting the springback angle in sheet metal bending. Predicting the springback is important since to produce the accuracy part geometry, the design of the die and bending tool must be accurate. This thesis aims to evaluate the reliability of finite element method by comparing the results with experimental results. The effect of parameters such as anisotropy in springback also has been studied. Abaqus software has been used to simulate the bending process and the mechanical properties provided from tensile test will be used to run the  simulation. In the U-bending experiment, the die were clamped on stamping machine and the Galvanized Iron sheets then have been bent before the springback being measured with SolidWorks software. The results from the experiment and simulation is slightly different for the springback angle Ɵ1 , which the simulation shows increasing the orientation will increase the springback, and for the experimental, the springback higher at 0 degree orientation angle, and lower at 45 degree. For the springback angle Ɵ2 , the simulation and experimental result show that increasing the orientation angle will increase the amount of springback. Finite element method can be used to predict the springback since the results are nearly the same and percentages of error are below 10 %. It can be comprehended that the finite element method are suitable method to predict the springback angle of sheet metal bending. The finite element method is important in the future. 0aFinite element method  00104071a20000b20000d2019-09-04l0oTA347.F5 F35 2013 r Bc.p0000086551r2019-09-04 00:00:00t1w2019-09-04yPSM  00104071a20000b20000d2019-09-04l0oCD 8215 | TA347.F5 F35 2013 r Bc.p0000086552r2019-09-04 00:00:00t1w2019-09-04yPSM  aVIRTUA40c5087d5093  aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992