02789ntm a2200253 a 4500 vtls000082931 KUKTEM 20251117113232.0 141104t2013 my da f m 000 0 eng|d THE0005891(Local) 201905141155 aida 201411050949 training2 201411041120 training2 201411041118 training2 201411041054 training2 UMP TA465 .N33 2013 r Bc. Mohd Nadzrizal Mohamad Ghaazali The study of joining strength based on differential joining technique / Mohd Nadzrizal Mohamad Ghaazali Kuantan, Pahang : UMP, 2013 xiii, 50 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project Paper (Bachelor of Mechanical Engineering (Automotive)) -- Universiti Malaysia Pahang – 2013 Bibliography : p. 51-52 In this thesis, the objective is to study the joining strength based on different joining technique. The focus objective joining strength in this thesis is the spot welding and the adhesive bonding. This technique need to study the effectiveness of the spot welding and adhesive bonding used to join the car body parts and strength of this method need to be analyses. The method used in this thesis are used the five different material with combination with specimen A and A, B and B. The joining used are spot weld and adhesive been applied with the different thickness in 0.65 mm, 0.7 mm and 1.0 mm. the type specimen used are SPCUD 35, SPC 440, PR SPCD, SPCD 440, and INR SPCD. To study the strength of these method, tensile test have been conducted. The experiment been conducted by load vs displacement and strength vs material. The experiment findings showed those spot weld and adhesive bonding with same material shows different strength and also different effect to the parent material. Spot weld bonding will affect the microstructure of specimen and been harden the bonding of joining spot weld. When the force applied higher than strength of the joining, the resistance area around nugget of spot weld start to crack and failure happen at around the nugget itself not at nugget welding. The strength of the spot weld is depending on the strength of material and thickness of material applied to the joining. The strength of adhesive bonding is depending on type of adhesive and surface roughness of the material itself. The shear test shows the adhesive bonding have an average 5.43 MPa and spot weld joining is 6.79 MPa not much different Based on experimental result, adhesive bonding is applicable for automotive body joining. Joining and Testing Strength of materials 0 0 0 1 20000 20000 2019-09-04 0 TA465 .N33 2013 r Bc. 0000086414 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 8147 | TA465 .N33 2013 r Bc. 0000086415 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 5175 5181 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992