02791ntm a2200241 a 4500 vtls000082874 KUKTEM 20251117113244.0 141103t2013 my da f m 000 0 eng d THE0005795(Local) 201905131421 aida 201411031537 Fida 201411031536 Fida 201411031535 Fida UMP TA418.74 .A39 2013 r Bc. Adzmil Abdul Aziz Analysis of burst pressure on elbow and t-section in the presence of defect / Adzmil Abdul Aziz Kuantan, Pahang : UMP, 2013 xv, 80 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2013 Bibliography: p.78-79 This study focuses on the development of short hydrostatic burst model of PVC fittings and their analysis. The experiments of burst pressure for fittings are hardly can be seen to be carried out either by industry or by researchers and especially for PVC fittings. This situation exists because of many reasons. One of them is the difficulty of getting a superb; zero leaks for PVC material. As for example, in hydrostatic burst test that involves metal, the technique of welding and thread are widely available for them for the jointing procedures. As for PVC cement, the most practical jointing procedure is only by using PVC cement. However, this method has high probability of leakage even if any small mistake done during the jointing process. In addition, parallel to the low pressure application of PVC fittings, there is no requirement in industry to have data on the PVC fittings burst pressures. After a well reliable model design is achieved, and then the main focus is to observe and analyze the effect of defected PVC model on its burst pressure. This is the main objective in this analysis. In a circuit of PVC piping installation, the is small probability for the fittings to break due to internal pressure as the thinner and weaker straight pipe will breaks first. However, in the presence of defect on fittings, the piping break can occur on fittings. In the experimental analysis, both perfect and defected fitting are to be obtained their burst pressures. Analysis will be carried out on both data to see the pattern of effect of defected fittings and also able to predict its left strength using previous solution. The expected result produces from the experiment is the burst pressure of the PVC fittings will be getting lower as the depth of defect introduced increases. Defected fittings will be less resistant to internal pressure. Corrosion and anti-corrosives 0 0 0 1 20000 20000 2019-09-04 0 TA418.74 .A39 2013 r Bc. 0000086392 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 8137 | TA418.74 .A39 2013 r Bc. 0000086393 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 5553 5559 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*9992