01832ntm a2200265 a 4500 vtls000083208 KUKTEM 20251117113244.0 141110t2013 my da f m 000 0 eng d THE0004927(Local) 201905131514 SHAHRILJ 201502020958 fawwaz 201411131337 training1 201411101222 training1 UMP TP1150 .K37 2013 r Bc. Karen, Yap Chia Ern A study of defects reduction in injection process of production line / Karen Yap Chia Ern Kuantan, Pahang : UMP, 2013 xii, 62 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Faculty of Engineering Technology Project Paper (Bachelors of Industrial Technology Management with Honours) -- Universiti Malaysia Pahang – 2013 Bibliography : p. 55-57 This study was conducted to analyze various factors of defects in injection moulding process of the production line of manufacturing organization. Based on some reading material such as, journal, book and some study states that some factors such as machine, man, mould, method, technology and material caused defects in injection moulding process. The objective of this study is to determine the factors that caused defect in injection moulidng process in production line. Interview secession will be conducting with production line and several departments manager to have some discussion and observation about the study. In the nut shell, I wish that this study will be one of the references to be use in future and may be can have some improvement for this study. Injection molding of plastics Production lines 0 0 0 1 10000 10000 2019-09-04 0 TP1150 .K37 2013 r Bc. 0000090152 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 10000 10000 2019-09-04 0 CD 8441 | TP1150 .K37 2013 r Bc. 0000090153 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 5569 5575 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5000*5020*5040*5200*6500*6501*9992