01940nam a2200241 a 4500 vtls000030094 KUKTEM 20251114204347.0 080709t2007 my f m 000 0 eng|d THE0007765(Local) 201905241512 fawwaz 201107132029 VLOAD 200908141457 VLOAD 200908141428 VLOAD 200807091544 kam UMP TS1549.G5 N39 2007 rs Mohd Nazmi Mohd Nordin Design and fabrication of MS88 fiberglass helmet / Mohd Nazmi Bin Mohd Nordin Kuantan, Pahang : UMP, 2007 49 p. : ill. (some. col.) ; 30 cm. Project paper (Diploma of Mechanical Engineering) -- Universiti Malaysia Pahang - 2007 The fabrication of MS88 fibre glass helmet project was focused in design and fabricates the fibreglass helmet. The design of mould based on MS88 design helmet. The mould use polystyrene material coated by aluminium foil. Using the fibreglass as a main material for fabrication, it can reduce the mass of the helmet and increase the conformability to wear. The process to fabricate the fibreglass helmet is called "lay up" process where the fibreglass mat is applied on the mould layer by layer with the mixture of 99% of polyester resin and 1 % of hardener. However the surface of fibre glass helmet is not smooth enough because of the sphere shape of mold make it hard to apply the fibreglass mat. After the helmet was fabricated, the samples of fibreglass are tested using Compression Testing machine to measure the mechanical properties of fibreglass reinforce plastic(FRP). The overall project can be described as successfully project because the MS88 fibreglass helmet manages to fabricate in the time given. -Author Glass fibers Helmets Design and construction 0 0 0 1 20000 20000 2019-09-04 0 TS1549.G5 N39 2007 rs 0000030644 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 672 678 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5200*6500*6501*9992