01897nmm a2200313 a 4500 vtls000098440 KUKTEM 20251117113331.0 161214s2016 my fq d 001 0 eng d THE0005113(Local) 201905131513 hanafiah 201712121405 fateeha 201612141019 saini UMP FKP .A363 2016 r Bc. CD 10444 Muhammad Aiman Ishak Development of ceramics cutting tool for machining using aluminium oxide reinforced with copper powder [electronic resource] / Muhammad Aiman Ishak Kuantan, Pahang : UMP, 2016 1 computer disc : digital data ; 12 cm. Faculty of Manufacturing Engineering Theses Gred B Project Paper (Bachelor of Engineering in Manufacturing Engineering (Hons.)) -- Universiti Malaysia Pahang – 2016 Powder metallurgy (processing) method was used to produce an insert for machining application. An alumina (Al2O3) powder reinforced with Copper power was used as a raw material. A complete die was produced for the insert production. Powder mixing, compaction and sintering using open air furnace were the main processing parameters in the research project. The composite insert was analyzed for density and hardness properties. The result showed that 90% of the theoretical density was achieved and 70% by weight mixed with 30% copper was measured for the higher Vickers hardness value. Item in PDF format Faculty of Manufacturing Engineering Dissertations Universities and Colleges Dissertations Theses http://ecollib.ump.edu.my/id/eprint/3971 Access in library only 0 0 0 1 20000 20000 2019-09-04 0 FKP .A363 2016 r Bc. | CD 10444 0000115959 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 6900 6906 VTLSSORT0080*0200*0400*0900*0901*1000*2450*2600*3000*5000*5001*5020*5200*5380*6100*6500*6501*8560*9992