02135ntm a2200289 a 4500 vtls000098279 KUKTEM 20251117113340.0 161206s2016 my da f abm 000 0 eng d THE0000099(Local) 201905131332 aishah 201712141642 saini 201612061523 saini 201612060943 saini UMP FIM .W66 2016 r Bc. Wong, Eng How A study of simulation modeling in door frame production / Wong Eng How Kuantan, Pahang : UMP, 2016 xv, 97 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Faculty of Industrial Management Project Paper (Bachelor Degree (Hons) of Industrial Technology Management) -- Universiti Malaysia Pahang – 2016 Bibliography : p. 91-94 This study discusses about assessing and enhancing the production line in door frame industries by using simulation method. The scope of this study is focusing on the production processes of a Door Frame Factory. The time frame covered is one year which is in year 2015. Simulation is a planning tool, implemented in the processes which required by the factory to meet the changing demands of the products. Modeling door frame production will be developed using Arena simulation software to test run and make comparison with the real world system. It is a quantitative study which the performance of the processes is measured by average wait time, machine utilization and operator utilization for the entire system of door frame production. The results obtained from the simulation software will act as an attempt to simulate the “What-If Analysis” scenarios to forecast the performance of real world system without developing costly implementation. Faculty of Industrial Management Dissertations Universities and Colleges Dissertations Theses http://ecollib.ump.edu.my/id/eprint/4156 Access in library only 0 0 0 6 10000 10000 2019-09-04 0 FIM .W66 2016 r Bc. 0000115616 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 6 10000 10000 2019-09-04 0 CD 10373 | FIM .W66 2016 r Bc. 0000115617 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 7162 7168 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5000*5020*5040*5200*6100*6500*6501*8560*9992