03099ntm a2200313 a 4500001001400000003000700014005001700021008004100038020002200079039006800101040000800169090002600177100002400203245012200227260003400349300006500383500005000448502011500498504002500613520158300638610006502221650004502286650001102331856007002342952012002412952013102532999002502663999009702688vtls000102348KUKTEM20251117113357.0171102s2017    my da  f abm  000 0 eng d  aTHE0000139(Local) 9a201905131249bnazirahc201712141239dnazriy201711021005zsaini  aUMP  aFIST .F374 2017 r Bc.0 aNor Fashilin Azahar10aStudy on preparation and properties of hybrid kenaf fiber and sawdust particleboard composite  /cNor Fashilin Azahar  aKuantan, Pahang :bUMP,c2017  axvi, 24 p. :bill. (some col.), charts ;c30 cm. +e1 CD-ROM  aFaculty of Industrial Sciences and Technology  aProject Paper (Bachelor of Applied Science (Honor) Material Technology) -- Universiti Malaysia Pahang – 2017  aBibliography : p. 243 aThis thesis reports study of Hybrid kenaf fiber and Sawdust particleboard composite using urea formaldehyde and phenol formaldehyde and its physical and chemical properties. Hybrid particleboard are introduced as an alternative for traditional particleboard. The objectives of this research are to prepare hybrid kenaf fiber and sawdust particleboard composite, to determine the physical and mechanical properties of hybrid kenaf fiber and sawdust particleboard composite and to characterize hybrid kenaf fiber and sawdust particleboard composite by using scanning electron microscopy (SEM) and thermogravimetric analysis (TGA). Hybrid kenaf and sawdust particleboard are formed by mixing kenaf fiber and sawdust particle together with urea formaldehyde (UF) or phenol formaldehyde (PF). Before mixing with resin, both kenaf fiber and sawdust particleboard are needed to be grind to obtain powder form. After mixing with resin, the particleboard then placed into a mold and hot pressed. Then, the particleboard undergo conditioning for one week before being cut for physical and mechanical testing. Then, the kenaf fiber particleboard is characterized by using Thermogravimetric Analysis (TGA) and Scanning Electron Microscopy (SEM). Hybrid particleboard with phenol formaldehyde do not swell too much and hybrid particleboard with urea formaldehyde has higher tensile strength. From the SEM images, the UF resin and PF resin used are identified. After being tested, hybrid particleboard with phenol formaldehyde has better bond than hybrid particleboard with urea formaldehyde.20aFaculty of Industrial Sciences and TechnologyxDissertations 0aUniversities and CollegesxDissertations 0aTheses40uhttp://ecollib.ump.edu.my/id/eprint/28005zAccess in library only  00104071a10000b10000d2019-09-04l0oFIST .F374 2017 r Bc.p0000119922r2019-09-04 00:00:00t1w2019-09-04yPSM  00104071a10000b10000d2019-09-04l0oCD 10872 | FIST .F374 2017 r Bc.p0000119923r2019-09-04 00:00:00t1w2019-09-04yPSM  aVIRTUA40c7611d7617  aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5000*5020*5040*5200*6100*6500*6501*8560*9992