02010ntm a2200241 a 4500001001400000003000700014005001700021008004100038020002200079040000800101100002400109245009900133260003400232300006400266500005000330502011500380504002800495520105400523610006501577650004501642650001101687856007001698vtls000102356KUKTEM20251117113358.0171102s2016    my da  f abm  000 0 eng d  aTHE0000121(Local)  aUMP0 aNoor Athirah Ismail10aFabrication of nickel-cobalt intermetallic nanotapes by electrospinning /cNoor Athirah Ismail  aKuantan, Pahang :bUMP,c2016  axv, 38 p. :bill. (some col.), charts ;c30 cm. +e1 CD-ROM  aFaculty of Industrial Sciences and Technology  aProject Paper (Bachelor of Applied Science (Honor) Material Technology) -- Universiti Malaysia Pahang – 2016  aBibliography : p. 36-383 aThis dissertation thesis is on the fabrication of Nickel-Cobalt nanotapes prepared by electrospinning technique. Electrospinning is a nanofabrication technique in which a polymeric solution is allowed to pass through an electric field of intensity ~105 V/m. In this work, the precursor polymeric solution was prepared by dissolving equimolar nickel acetate (18 mmol) and cobalt acetate in 50 wt.% polyvinylpyrrolidone (Mol. Wt. 40,000) in ethanol. The viscosity of the above solution was measured using a viscometer; the viscosity of the solution was ~653 cP. This solution was electrospun using a commercial electrospinning unit at 24 kV with a solution injection rate 0.5 ml/h. The as-spun fibers were annealed in an argon atmosphere at ~450 – 550oC for 1 h, based on thermogravimetric analysis. The annealed materials were examined by X-ray diffraction (XRD) technique and field emission scanning electron microscopy (FESEM). The XRD measurements showed that the annealed samples were only partially crystallized and has a belt-like morphology.20aFaculty of Industrial Sciences and TechnologyxDissertations 0aUniversities and CollegesxDissertations 0aTheses40uhttp://ecollib.ump.edu.my/id/eprint/28000zAccess in library only