02262ntm a2200301 i 4500001001400000003000700014005001700021008004100038020002200079040002300101100004100124245010300165264003400268300006900302336002100371337002500392337002300417338002300440338003000463347002400493500004100517502019400558504004000752520105700792610005601849650004401905650001101949vtls000103579KUKTEM20251117113401.0180523s2018    my a   f am   000 0 eng d  aTHE0005387(Local)  aUMPbengcUMPerda0 aNurul Muhayu Ashikin Rukmi,eauthor.10aOptimum parameter setting for potting machine on inductance products /cNurul Muhayu Ashikin Rukmi 1aKuantan, Pahang :bUMP,c2018  axi, 50 pages :billustrations (some color) ;c30 cm. +e1 CD-ROM  atext2rdacontent  aunmediated2rdamedia  acomputer2rdamedia  avolume2rdacarrier  acomputer disc2rdacarrier  atext filebPDF2rda  aFaculty of Manufacturing Engineering  aProject Paper (Bachelor of Mechatronics Engineering (UMP-HsKA)) - (Dual Degree Programme with Karlsruhe University of Applied Sciences, HsKA, Germany) -- Universiti Malaysia Pahang – 2018  aIncludes bibliographical references3 aThis thesis is about the improvement of the existing process on potting machine for inductance products in an industrial company, Vacuumschmelze Sdn. Bhd., located in Pekan, Pahang. In order to achieve the objective which is to make an improvement on the potting process, a method for optimization is conducted to investigate the best parameter that should be used on the potting machine that depends on the model of inductance. The approach in this project is based on the design of experiment of Taguchi method to determine the setting of the process parameters due to its precision, low cost and low time consuming, systematic and easy to analyze the result. Orthogonal Arrays of Taguchi, the signal and noise ratio, the analysis of variance (ANOVA) are employed to find the optimum parameter levels of factors. The results obtained from the experiment in Taguchi technique is analyzed using statistical software, Minitab. Confirmation test with the optimum level obtained is carried out to investigate the effectiveness of the experiment conducted.20aFaculty of Manufacturing EngineeringxDissertations 0aUniversities and collegesxDisertations 0aTheses