02012nam a2200253 a 4500 vtls000045549 KUKTEM 20251114204352.0 100504t2009 my a f m 000 0 eng d THE0007460(Local) 201905161232 fawwaz 201204051129 Fida 201107132044 VLOAD 201005041348 ida UMP TP1150 .D47 2009 rs Bc. Siti Dermira Arifin Design of three plate mould and cooling channels analysis/ Siti Dermira Binti Arifin Kuantan, Pahang : UMP, 2009 70 p. : ill. (some col.) ; 30 cm. + 1 CD-ROM Project paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2009 Includes bibliographical references Nowadays, demands on product base on plastic is increase from day to day because the product that made from plastic are capable of competing with any other product that made from other sources of raw material in terms of its quality. It is also cheaper compare to any other materials and also the manufacturing process of making these plastics product take shorter time than the other material. In order to manufacture the plastics product with a very good quality, some process should be done and the most important process in the design stage.Because of it, it can be produce in many type of mould such as three-plate mould, two-plate mould, hot runner mould and also cold runner mould. In order to obtain a perfect product without any defect some flow analysis on the product will be conduct. This study will use the Moldflow Plastic Insight (MPI) software in analysing the product. The analyses of the cooling channels location will also being done so that to make sure a constant plastics flow obtain. Injection molding of plastics Plastics Molding 0 0 0 1 20000 20000 2019-09-04 0 TP1150 .D47 2009 rs Bc. 0000044403 2019-09-04 00:00:00 1 2019-09-04 PSM 0 0 0 1 20000 20000 2019-09-04 0 CD 4225 | TP1150 .D47 2009 rs Bc. 0000044404 2019-09-04 00:00:00 1 2019-09-04 PSM VIRTUA40 835 841 VTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5040*5200*6500*6501*9992