| 000 | 01930nam a2200241 a 4500 | ||
|---|---|---|---|
| 001 | vtls000040007 | ||
| 003 | KUKTEM | ||
| 005 | 20251114204404.0 | ||
| 008 | 090709t2008 my a f m 000 0 eng d | ||
| 020 | _aTHE0006593(Local) | ||
| 039 | 9 |
_a201905161040 _bamirul _c201107132151 _dVLOAD _c200908141646 _dVLOAD _c200908141624 _dVLOAD _y200907091514 _zkam |
|
| 040 | _aUMP | ||
| 090 | _aTJ1191 .S53 2008 rs Bc. | ||
| 100 | 0 | _aAhmad Shazwi Kamaruzaman | |
| 245 | 1 | 0 |
_aCarbon Dioxide (CO2) laser cut quality of acrylic / _cAhmad Shazwi Bin Kamaruzaman |
| 260 |
_aKuantan, Pahang : _bUMP, _c2008 |
||
| 300 |
_a53 p. : _bill. (some col.) ; _c30 cm. |
||
| 502 | _aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2008 | ||
| 520 | 3 | _aThis thesis presents the study of Acrylic were cut on CO2 laser cutting system and analyze the effects of power on cut quality. There are 2 cut quality involved during this thesis which are surface roughness and kerf width. Manual calculation analysis was used to investigate the effect of power on laser cut quality. The cutting process was implemented at apply power start from 15 – 28.5 W and 10 experiments were conduct during this thesis work. The feed rate will remain as constant variable parameter during this work study. Perthometer and image analyzer are conducted to examine the cut quality. From the analysis done, it was shown that the kerf width and surface roughness depends mainly on the laser power intensity. Power has great significance parameter in terms of improving productivity and good surface finish. As obtained through this thesis study, increasing the power intensity resulted in smaller value of surface roughness, Ra and higher value of kerf width. | |
| 650 | 0 | _aLaser beam cutting | |
| 650 | 0 |
_aCarbon dioxide lasers _xIndustrial applications |
|
| 999 |
_aVIRTUA40 _c1204 _d1210 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*1000*2450*2600*3000*5020*5200*6500*6501*9992 | ||