000			02053nam a2200265 a 4500
001			vtls000043024
003			KUKTEM
005			20251114204411.0
008			090902t2008 my a f m 000 0 eng d
020			_aTHE0005778(Local)
039		9	_a201905101559 _baida _c201107132222 _dVLOAD _y200909021256 _zida
040			_aUMP
090			_aTA418.7 .M64 2008 rs Bc.
100	0		_aRaja Mohd. Raja Idris
245	1	0	_aRelationship between machining parameters and surface roughness of brass using lathe machine / _cRaja Mohd. Raja Idris
246	3		_aRelationship between machining parameters and surface roughness of brass using lathe machine _h[electronic resource]
260			_aKuantan, Pahang : _bUMP, _c2008
300			_a39 p. : _bill. (some col.) ; _c30 cm. + _e1 computer disc
502			_aProject paper (Bachelor of Mechanical Engineering with Manufacturing) -- Universiti Malaysia Pahang - 2008
520	3		_aSurface roughness is a consequence of all machining operations and has been the subject of investigative research for the better part of the last century because the product produce good surface finish is very valuable. But, not all the product needs a good surface finish. If the product not demands a good surface finish, the time of machining can be reduce to minimize the cost. This is about the effect of machining parameters on surface roughness using lathe machine. The focus of this project is to study the effect of Cutting speed, feed rate, and depth of cuts on brass`s surface roughness. The experiment was design using Design of experiment (DOE) method and from which number of experiment was constructed. The result show that feed rate is the most effected parameter on surface roughness when machining process then followed by depth of cut and cutting speed. All the parameters are proportional with brass`s surface roughness.
650		0	_aSurface roughness
650		0	_aSurface (Technology)
650		0	_aBrass
999			_aVIRTUA40 _c1380 _d1386
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*6501*6502*9992