000 02794nam a2200253 a 4500
001 vtls000040728
003 KUKTEM
005 20251114204412.0
008 090723t2008 my a f m 000 0 eng d
020 _aTHE0006581(Local)
039 9 _a201905161026
_bamirul
_c201107132231
_dVLOAD
_c200908141651
_dVLOAD
_c200908141632
_dVLOAD
_y200907231104
_zida84
040 _aUMP
090 _aTJ1191 .K43 2008 rs Bc.
100 0 _aMohd Khairul Anuar Mohd Idris
245 1 0 _aEffects of machining characteristics on electric discharge machine using different electrode materials /
_cMohd Khairul Anuar Mohd Idris
246 3 _aEffects of machining characteristics on electric discharge machine using different electrode materials
_h[electronic resource]
260 _aKuantan, Pahang :
_bUMP,
_c2008
300 _a53 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer disc
502 _aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2008
520 3 _aElectric discharge machining (EDM) is a non-traditional machining processes that involved a transient spark discharges through the fluid due to the potential difference between the electrode and the work piece. The aim of this project is to determine the proper electrode material for machining tool steels work pieces using electrical discharge machining (EDM). Basically, improper choose of electrode material in EDM machine may result a few problems like the machine may cause of poor machining performance and it will decrease the accuracy of the products. This paper presents a fundamental study of characteristic of electrode discharge machine (EDM) that is electrode wear ratio (EWR) and material removal rate (MRR) by using different electrode materials in order to increase the understanding of EDM processes. To archive this project objective, an experiment will be doing properly. By following the method, some literature review is going to do first before preparing the experimental set-up. Then experiment will be runs and the data of the experiment are taken. This is to make sure the analysis can be done in order to find the best electrode material. There are three electrodes material should be compared that are copper, brass and aluminum. Regarding the literature review, the higher material removal rate in the EDM machine, the better is the machining performance while the lower electrodes wear ratio in the EDM machine is the better and accurate performance characteristic. Thus as the expected result for this experiment, the copper electrode material will be the best electrode among others electrode for EDM machining process.
650 0 _aElectric metal-cutting
650 0 _aMachining
999 _aVIRTUA40
_c1424
_d1430
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*6501*9992