000 02689nam a2200265 a 4500
001 vtls000045454
003 KUKTEM
005 20251114204424.0
008 100429t2009 my a f m 000 0 eng|d
020 _aTHE0003197(Local)
039 9 _a201905161447
_bzul
_c201107132316
_dVLOAD
_c201004291126
_dida
_c201004291125
_dida
_y201004291120
_zida
040 _aUMP
090 _aTD466 .R34 2009 rs Bc.
100 0 _aRahaiminullah Razali
245 1 0 _aZinc removal in biofilm reactor with support media /
_cRahaiminullah Bin Razali
246 3 _aZinc removal in biofilm reactor with support media
_h[electronic resource]
260 _aKuantan, Pahang :
_bUMP,
_c2009
300 _axii, 45 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer file
502 _aProject paper (Bachelor of Chemical Engineering) -- Universiti Malaysia Pahang - 2009
504 _aBibliography : p. 34-36
520 3 _aZinc removal in biofilm reactor with support media by mixed culture, attract a lot of interest from the public and as well as chemical industry. In this research, biofilm process was selected as a treatment method with using sequencing batchreactor (SBR).This method is better choice when compared in cost of treatment. Atthe beginning of the experiment, the mixed culture was collected from the drain and acclimatized in 10 litres reactor and the growth of mixed cultured is monitored by take suspended solid test. The mixed culture is acclimatized within two months by feed trace amount of glucose and 1mg/L of zinc. The hydraulic retention time (HRT) selected for this research is 5 days. Three parameters were chosen during run theexperiment which was suspended solid (SS) test for monitoring mixed culture growth while chemical oxygen demand (COD) removal and zinc removal for measure the water quality. This research will carry out by controlling the loading rate. The loading rate is choosing from 3 mg/L.d to 5 mg/L.d. The trend of results was determined. Based on result, increasing the loading rate make the all value of parameters decreased. The average value of SS in acclimatize reactor is 2645.39 mg/L. For the treatment reactor, the highest average value of SS is 566.21 mg/L. For COD removal and zinc removal, the highest average was at loading rate 3mg/L.d which is 41.49% and 75.01% respectively. Using Design-Expert programmed, the optimized data obtained. From the Design-Expert data, the zinc removal is 74.38% and the COD removal is 47.73%. The desirability of the lowest parameter of loading rate is 0.81.
650 0 _aWater
_xPurification
650 0 _aBiofilms
999 _aVIRTUA40
_c1766
_d1772
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992