000			02023nam a2200253 a 4500
001			vtls000045490
003			KUKTEM
005			20251114204424.0
008			100503t2009 my ao f m 000 0 eng d
020			_aTHE0006552(Local)
039		9	_a201905141534 _bamirul _c201107132316 _dVLOAD _c201005030901 _dida _y201005030830 _zida
040			_aUMP
090			_aTJ1187 .P47 2009 rs Dip
100	0		_aPerabu Moorty
245	1	0	_aDesign and fabrication test jig for cervical bone / _cPerabu a/l Moorty
246	3		_aDesign and fabrication test jig for cervical bone _h[electronic resource]
260			_aKuantan, Pahang : _bUMP, _c2009
300			_axiv, 53 p. : _bill. (some col.) ; _c30 cm. + _e1 computer disc
502			_aProject paper (Diploma of Mechanical Engineering) -- Universiti Malaysia Pahang - 2009
504			_aBibliography : p.47
520	3		_aThis thesis deals with the development of cervical bone test jig. The objectives of this thesis are to design the test jig for cervical bone, fabricate the parts and assemble the parts together to complete the cervical bone test jig. The thesis describes the methods of designing and fabricating the mechanical part of the gate system. There the many steps taken to design and fabricate the mechanical part of the gate system. The structural three-dimensional solid modelling of test jig was developed by usingthe SolidWorks engineering drawing software. The fabrication process also undergoes many steps such as material marking, cutting, drilling, welding and grinding. Other than that, it is explaining the procedure of testing where the cervical bone of cow “bovine” to operate the mechanism of the test jig. The results of testing the jig also discussed in this thesis. Finally, the conclusion about this project and the recommendations for the future plan also attached together with this thesis
650		0	_aJigs and fixtures _xDesign and construction
999			_aVIRTUA40 _c1771 _d1777
999			_aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*9992