000 02214nam a2200265 a 4500
001 vtls000045506
003 KUKTEM
005 20251114204425.0
008 100503t2009 my ao f m 000 0 eng|d
020 _aTHE0006508(Local)
039 9 _a201905141306
_bamirul
_c201107132316
_dVLOAD
_y201005031707
_zida
040 _aUMP
090 _aTJ1185 .K43 2009 rs Bc.
100 0 _aAhmad Khairul Hafizi Wahab
245 1 0 _aEffects of punching force on cutting tool in forming process using FEA approach /
_cAhmad Khairul Hafizi Bin Wahab
246 3 _aEffects of punching force on cutting tool in forming process using FEA approach
_h[electronic resource]
260 _aKuantan, Pahang :
_bUMP,
_c2009
300 _axv, 55 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer disc
502 _aProject paper (Bachelor of Mechanical Engineering with Manufacturing Engineering) -- Universiti Malaysia Pahang - 2009
504 _aBibliography : p. 43-44
520 3 _aThis thesis deals with sheet metal forming process. There are two main objectives of this research, firstly, to analysis the cutting tool wear in different force of punching and clearance and the second objective is to predict the critical part or part that will wear first on the cutting tool. In sheet metal forming process, quality of product and minimize the production cost is very important. The tool wear will affect the quality of product and increase the production cost of manufacturing. In the ALGOR simulation, the tool wear will determined by analyse stress on cutting tool. In addition, the wear tool would be high as stress at the cutting edge was extremely high. This project will considered punch force and clearance between punch and die to analysis the tool wear. The punching force used for this project are 100kN, 140kN and 180kN. The range of percentage used for clearance between punch and die used in this project are between 1.70% to 3.3%. These two parameters which are the punch force and clearance is very important for tool life and the final product.
650 0 _aMetal-cutting
650 0 _aPunching (Metal-work)
999 _aVIRTUA40
_c1783
_d1789
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992