| 000 | 02559nam a2200265 a 4500 | ||
|---|---|---|---|
| 001 | vtls000046033 | ||
| 003 | KUKTEM | ||
| 005 | 20251114204428.0 | ||
| 008 | 100608t2009 my da f m 000 0 eng d | ||
| 020 | _aTHE0006502(Local) | ||
| 039 | 9 |
_a201905141241 _bamirul _c201107132324 _dVLOAD _y201006081128 _zFida |
|
| 040 | _aUMP | ||
| 090 | _aTJ1185 .F38 2009 rs Bc. | ||
| 100 | 0 | _aMohamad Fauzi Rosly | |
| 245 | 1 | 0 |
_aMaterial selection in mechanical design of cutting tools / _cMohamad Fauzi Bin Rosly |
| 246 | 3 |
_aMaterial selection in mechanical design of cutting tools _h[electronic resource] |
|
| 260 |
_aKuantan, Pahang : _bUMP , _c2009 |
||
| 300 |
_axvii, 74 p. : _bill. (some col.) ; _c30 cm. + _e1 computer disc |
||
| 502 | _aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2009 | ||
| 504 | _aBibliography : p. 57-58 | ||
| 520 | 3 | _aThis thesis was carried out as a study of Material selection in mechanical design of cutting tool The objectives of this study are to perform material selection process for find the best material that can be use as cutting tools material, compare the alternative method with conventional method and use Computer-aided selection software (CES) to find the best process for cutting tools manufacturing. Weighted property method as alternative method and cost per unit property method as conventional method was performing for finding the suitable material for cutting tools. The material selected from these two methods was compared to find the best selected material. Before performing weighted property method, material performance index, M, was finding first. To finding the materials performance index, M, derivation of basic formula like stiffness and cross section must perform first. Function of materials performance index, M, was plotted on the Young’s modulus – density chart and wear rate– hardness chart. In cost per unit property method, the best material was selected based on the smaller value of cost per unit property. After selection by using cost per unit property has done, weighted properties method was performing. The material selection is making by referring to the performance index. The highest value of performance index represents the best material for cutting tools. Lastly, computer Aided selection process was used to find the suitable manufacturing process for selected material. | |
| 650 | 0 | _aMetal-cutting | |
| 650 | 0 | _aMetal-cutting tools | |
| 999 |
_aVIRTUA40 _c1872 _d1878 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992 | ||