| 000 | 01931nam a2200253 a 4500 | ||
|---|---|---|---|
| 001 | vtls000054845 | ||
| 003 | KUKTEM | ||
| 005 | 20251114204437.0 | ||
| 008 | 110718t2009 my a f m 000 0 engd | ||
| 020 | _aTHE0006756(Local) | ||
| 039 | 9 |
_a201905290912 _bamirul _c201107181648 _dida _y201107181638 _zida |
|
| 040 | _aUMP | ||
| 090 | _aTK2785 .F38 2010 rs Bc. | ||
| 100 | 0 | _aMuhammad Fauzi Muain | |
| 245 | 1 | 0 |
_aStep motor speed controller / _cMuhammad Fauzi Muain |
| 246 | 3 |
_aStep motor speed controller _h[computer file] |
|
| 260 |
_aKuantan, Pahang : _bUMP, _c2010 |
||
| 300 |
_axii, p. : _bill. (some col.) ; _c30 cm.+ _e1 computer disc |
||
| 502 | _aProject paper (Bachelor of Electrical Engineering (Power Systems)) -- Universiti Malaysia Pahang - 2010 | ||
| 504 | _aBibliography : p. [48]-50 | ||
| 520 | 3 | _aStepper motors are used in many devices and appliances that are part of our everyday life. Sensing variables such as position, velocity or current for the purpose of control is a common problem in many industrial drive applications .Sensing signals that truly represent system variables, such as absolute shaft position, may be a difficult either because of cost or physical limitations. In such cases we must estimate all or some of the missing variables from limited measurements that may be noisy. This project summarizes and shows how to estimate rotor speed using microcontroller. The microcontroller which was used for this purpose is PIC16F84A. Programmable Interface Controller (PIC) 16F84A is use for control the rotation and speed of stepper motor by using the coding that program in software. Coil, coil, coil and coil are controlled by the software. A program in MPLAB IDE is developed to provide a coding to make a HEX file and transfer using PICkit 2 into PIC16F84A | |
| 650 | 0 | _aStepping motors | |
| 999 |
_aVIRTUA40 _c2155 _d2161 |
||
| 999 | _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*9992 | ||