000 02286nam a2200265 a 4500
001 vtls000051476
003 KUKTEM
005 20251114204438.0
008 110224t2010 my da f m 000 0 eng d
020 _aTHE0005885(Local)
039 9 _a201905141147
_baida
_c201107140034
_dVLOAD
_y201102241358
_zida
040 _aUMP
090 _aTA462 .Y43 2010 rs Bc.
100 1 _aYeap, Leong Hooi
245 1 0 _aCorrosion prevention of steel sample in aqueous solutions and its mechanical properties /
_cYeap Leong Hooi
246 3 _aCorrosion prevention of steel sample in aqueous solutions and its mechanical properties
_h[electronic resource]
260 _aKuantan, Pahang :
_bUMP,
_c2010
300 _axvii, 92 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer disc
502 _aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang - 2010
504 _aBibliography : p. 71-72
520 3 _aCorrosion has become a main issue for all engineering sector in these few decades. The main purpose of this project is to investigate the corrosion prevention method in order to slow down the process of corrosion and to investigate the effect of the prevention method on the mechanical properties of those sample specimens. Three methods applied on the steel samples which are nickel electroplating, zinc electroplating and powder coating. The corrosion rate was determined by using weight loss method in immersion test according to ASTM G31, whereas the mechanical properties to be investigated were hardness and tensile test. The dimension of tensile test specimens was followed the ASTM E-8M. The results obtained show that the corrosion rate of the coated specimen was lower than that of the specimen without coating. The specimen with nickel electroplating has the lowest corrosion rate among the coated specimens, followed by powder coating and zinc electroplating. The coated specimens also have the higher value in hardness; yield strength and ultimate tensile strength, where the nickel electroplating has the highest value among all others specimens.
650 0 _aCorrosion and anti-corrosives
650 0 _aCorrosion and anti-corrosives
_xTesting
999 _aVIRTUA40
_c2165
_d2171
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*9992