000 03031nam a2200253 a 4500
001 vtls000051432
003 KUKTEM
005 20251114204458.0
008 110209t2010 my a f m 000 0 eng d
020 _aTHE0007385(Local)
039 9 _a201905151139
_bfawwaz
_c201107140032
_dVLOAD
_c201102091434
_dida
_c201102091427
_dida
_y201102091415
_zida
040 _aUMP
090 _aTL706.T4 H37 2010 rs Bc.
100 0 _aWan Mohd Hasif Wan Haron
245 1 0 _aComputational fluid dynamics analysis of propeller with and without fins /
_cWan Mohd Hasif Wan Haron
246 3 _aComputational fluid dynamics analysis of propeller with and without fins
_h[electronic resource]
260 _aKuantan, Pahang :
_bUMP,
_c2010
300 _a49 p. :
_bill. (some col.) ;
_c30 cm.+
_e1 computer disc
502 _aProject paper (Bachelor of Mechanical Engineering with Automotive) -- Universiti Malaysia Pahang - 2010
520 3 _aThe project objectives are to ensure that the simulation results are valid by comparison with the Standard Series Data and compare the performance of propeller with and without fins, based on Computational Fluid Dynamics (CFD) analysis. The propeller is based on Wageningen B3.55 series and made from aluminium alloy. Theoretically the fins on the back side of propeller blade will increase the thrust produce by the propeller. The methodology of this project can be divide to three parts depends on the software used; PolyWorks, SolidWorks and CosmosFloWorks. The propeller is divided into two, with and without fins. A propeller with two fins in the format of PolyWorks file after the propeller had through 3D scan process is provided, thus further 3D modeling process using PolyWorks had to be made. Other than to process the propeller to desired shape, 3D modeling also used to smoothen the surface, eliminate any defects like hole and gaps on the surface of propeller. SolidWorks is important software in this project not only because it can read the IGES file format from PolyWorks, also CosmosFloWorks is the plug-in for SolidWorks. The function of CosmosFloWorks is to analyze the performance of propellers where the value of thrust and torque is taken. Thrust is the force produced at a given speed when propeller rotates and torque is the moment act on the propeller blades. The value of thrust and torque from Standard Series Data and analysis of propeller without fins is compared to make sure the data from analysis is valid. It is observed that the value of thrust from Standard Series Data is higher than the thrust value from propeller without fins around 4.3% and 2.6% for torque. The velocity of boat is set from 3 knots to 7 knots and the slippage is not considered in the analysis. The average increase of thrust by the propeller with fins compare to propeller without fins is around 9.1% and 4.4% for torque value.
650 0 _aPropellers
_xFluid dynamics
650 0 _aPropellers
_xTesting
999 _aVIRTUA40
_c2750
_d2756
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5200*6500*6501*9992