000 02631nam a2200277 a 4500
001 vtls000052298
003 KUKTEM
005 20251114204459.0
008 110325t2010 my da f m 000 0 eng d
020 _aTHE0006489(Local)
039 9 _a201905141228
_bamirul
_c201110040951
_dFida
_c201107140041
_dVLOAD
_c201103251152
_dida
_y201103251149
_zida
040 _aUMP
090 _aTJ1077 .Z85 2010 rs Bc.
100 0 _aMohd Zulhilmi Rifin
245 1 0 _aEffect of lubrication condition on surface roughness in turning operation /
_cMohd Zulhilmi Rifin
246 3 _aEffect of lubrication condition on surface roughness in turning operation
_h[ computer file]
260 _aKuantan, Pahang :
_bUMP,
_c2010
300 _axvii, 86 p. :
_bill. (some col.) ;
_c30 cm. +
_e1 computer disc
502 _aProject paper (Bachelor of Mechanical Engineering) -- Universiti Malaysia Pahang -- 2010
504 _aBibliography: p. 79-80
520 3 _aMinimum quantity of lubrication (MQL) in machining is an established alternative to completely dry or flood lubricating system from the viewpoint of cost, ecology and human health issues. Hence, it is necessary to select MQL and cutting conditions in order to enhance machinability for a given work material. This thesis describes experimental investigations on influence of different lubrication conditions such as minimum quantity lubrication (MQL), dry machining and wet machining on surface roughness. The surface roughness was examined with Perthometer. In this research, the main objective is to determine the effect of the lubrication conditions on the surface roughness in turning operation. Three different materials had been chosen as work material. Those were ASTM B176 Brass, AISI 1060 Aluminum Alloy and AISI 304 Stainless Steel. Two other parameters were also considered in this study; depth of cut and cutting speed. The ranges of depth of cut used were 0.2mm and 0.4mm whereby the cutting speed values were 810rpm and 1400rpm. Response Surface Method (RSM) was used to predict the surface roughness. Based on the generated results, the correlation for surface roughness with the cutting parameters satisfies a reasonable degree of approximation. It was found that, minimum quantity lubricants produced better surface finish as compared to dry and wet machining. The result can significantly reduce cost and environmental pollution by using minimum quantity lubrication.
650 0 _aMetal-working lubricants
650 0 _aSurface roughness
650 0 _aMachining
999 _aVIRTUA40
_c2771
_d2777
999 _aVTLSSORT0080*0200*0400*0900*1000*2450*2460*2600*3000*5020*5040*5200*6500*6501*6502*9992